data sheet no. pd 10035 rev k series pvg612pbf microelectronic power ic hexfet ? power mosfet photovoltaic relay single pole, normally open, 0-60v, 1.0a ac/ 2.0 a dc general description the pvg612 series photovoltaic relay is a sin gle- pole, normally open solid-state re lay that can replace electromechani cal re lays in many applications. it util - izes international rectifers proprietary hexfet power mosfet as the output switch, driven by an inte grated circuit photovoltaic gen erator of novel construction. the output switch is con trolled by radiation from a gaalas light emit ting diode (led) which is optically isolated from the photovol taic generator. these units exceed the performance capabilities of electromechanical relays in operating life, sensitivity, stability of on-resistance, miniaturization, insensitivity to magnetic felds and ruggedess. the compact pvg612 is particularly suited for isolated switching of high currents from 12 to 48 volt ac or dc power sources. series pvg612 relays are packaged in a 6-pin, molded dip package with either thru-hole or surface mount (gull-wing) termi nals. it is avail able in standard plastic ship ping tubes or on tape-and-reel. please refer to part identifca tion in formation opposite. features ? bounce-free operation ? high load current capacity ? high off-state resistance ? linear ac/dc operation ? 4,000 v rms i/o isolation ? solid-state reliability ? ul recognized ? esd tolerance: 4000v human body model 500v machine model applications ? programmable logic controllers ? computers and peripheral devices ? audio equipment ? power supplies and power distribution ? control of displays and indicators ? industrial automation part identifcation pvg612pbf thru-hole PVG612Spbf surface-mount PVG612S-tpbf surface-mount, tape and reel (hexfet is the registered trademark for international rectifer power mosfets) www.irf.com 1
series pvg612pbf www.irf.com 2 input characteristics limits units minimum control current (see fgure 1) 5.0 ma maximum control current for off-state resistance @ t a = +25c 0.4 ma control current range (caution: current limit input led, see fgure 6) 5.0 to 25 ma maximum reverse voltage 6.0 v output characteristics limits units operating voltage range 0 to 60 v (dc or ac peak) maximum load current @ t a = +40c, 10ma control (see fgure 1) a connection 1.0 a (ac or dc) b connection 1.5 a (dc) c connection 2.0 a (dc) maximum pulsed load current @ t a =+25c (100 ms @ 10% duty cycle) a connection 2.4a (ac or dc) maximum on-state resistance @t a =+25c for 1a pulsed load, 10ma control (see fgure 4) a connection 500 m? b connection 250 m? c connection 150 m? minimum off-state resistance @t a =+25c, 48v (see fgure 5) 10 8 ? maximum turn-on time @t a =+25c (see fgure 7) for 500ma, 50 v dc load, 10ma control 2.0 ms maximum turn-off time @t a =+25c (see fgure 7) for 500ma, 50 v dc load, 10ma control 0.5 ms maximum output capacitance @ 50v dc (see fgure 2) 130 pf electrical specifcations (-40c t a +85c unless otherwise specifed ) general characteristics limits units minimum dielectric strength, input-output 4000 v rms minimum insulation resistance, input-output, @t a =+25c, 50%rh, 100v dc 10 12 ? maximum capacitance, input-output 1.0 pf maximum pin soldering temperature (10 seconds maximum) +260 ambient temperature range: operating -40 to +85 c storage -40 to +100 connection diagrams international rectifer does not recommend the use of this product in aerospace, avionics, military or life support applications. users of this international rectifer product in such applications assume all risks of such use and indemnify international rectifer against all damages resulting from such use.
series pvg612pbf www.irf.com 3 ma x. lo ad cu rre nt (a ) am bi en t t em pe ra tu re (d eg . c ) 20 40 60 80 10 0 0 0. 25 0.50 0 1.00 1. 25 0. 75 i le d 10 ma 5 m a = 'a ' c on ne ct io n figure 1. current derating curves* figure 2. typical output capacitance ty pi ca l c ap ac it an ce (p f) vd d, dr ai n t o d ra in vo lt age (v ) 0 15 30 45 6 0 45 0 30 0 15 0 0 60 0 'a ' c on ne ct io n lo a d cu rr ent (a ) @2 5c , p ul se d 10 ma co nt ro l -0 .1 -0 .2 -0 .3 -0 .4 -0 .5 0. 50 1. 25 1. 00 0. 25 0. 75 -0 .2 5 -1 .2 5 -1 .0 0 -0 .7 5 -0 .5 0 0. 5 0. 4 0. 3 0. 2 0. 1 co n nec ti on 'a ' v ol ta ge dr op (v dd ) rd -o n ( no rm al i ze d t o 2 5 d eg. c ) am bi en t t em pe ra tu re (d eg . c ) 2. 5 2. 0 1. 5 1. 0 0. 5 0 -5 0 - 25 0 2 5 5 0 7 5 1 00 12 5 10 ma co nt ro l = 5 00 ma d i 'a ' c on nec ti on figure 3. linearity characteristics figure 4. typical normalized on-resistance * derating of b and c connection at +85c will be 70% of that specifed at +40c and is linear from +40c to +85c.
series pvg612pbf www.irf.com 4 le d c ur re n t ( ma ) de la y t im e ( mi cr os ec on ds ) 50 10 0 20 0 5 00 20 10 00 20 0 0 20 10 5 3 t of f t dl y t on 90% 10% i i le d d t dl y t on t of f figure 7. typical delay times figure 8. delay time defnitions am bi en t t em pe ra tu re (d eg . c ) -3 5 - 15 5 2 5 4 5 6 5 8 5 1 0 5 100 30 10 3. 0 1. 0 0. 3 0. 1 i d- of f 25 d eg. c / i d- of f in pu t c u rre nt (m a) le d f or wa rd vo lt ag e d ro p ( vo lt s d c) 16 20 12 8 4 0 0. 5 1 .0 1. 5 2. 0 0 no t e xc ee d e d t y p i c a l ca ut io n: pr ov id e c ur re nt li mi ti ng so th at 25 ma ma xi mu m s te a d y- st at e c o n tr ol c u rr en t r at in g is m i n . d e v i c e a n d + 8 5 d e g . c l i m i t m a x . d e v i c e a n d - 4 0 d e g . c l i m i t figure 5. typical normalized off-state leakage figure 6. input characteristics (current controlled)
series pvg612pbf www.irf.com 5 ir world headquarters: 233 kansas st., el segundo, california 90245 tel: (310) 252-7105 data and specifcations subject to change without notice. 2/2008 01-2008 01 case outlines 01-2009 01
|
